CMP121620000

Victron MultiPlus 1300 Watt 70 Amp Combi C12/1600/70-16

New product

$1,652.20

-10%

$1,486.98tax incl.

Reduced price!



** Note:

This model does Not have ac AC outlet built on the unit.
The unit must be wired up to an AC outlet.


The Victron MultiPlus 1300 Watt 70 Amp Combination unit is designed to give you the optimum in power flexibility. With incredible set up control and monitoring to you clean AC power when you need in most and charging battery maintenance when the batteries need it. The Victron Multiplus is designed as a single AC input, if you need a dual switchable AC input then you need to look at the Quattro Model.

So if you are looking for a European designed high quality Inverter Charger Combi unit the Victron MultiPlus 1300 Watt 70 Amp is perfect for most applications in your 4WD, Caravan, Motorhome, Bus, Truck, Boat or RV. The tough design will handle the harsh outback and still give you the exceptional power output and charging capabilities that you need.



Two AC Outputs

The main output has no break functionality. The MultiPlus takes over the supply to the connected loads in the event of a grid failure or when shore/generator power is disconnected. This happens so fast (less than 20 milliseconds) that computers and other electronic equipment will continue to operate without disruption.

The Victron MultiPlus 1300 Watt 70 Amp Combination unit is designed to give you the optimum in power flexibility. With incredible set up control and monitoring to you clean AC power when you need in most and charging battery maintenance when the batteries need it.

The second output is live only when AC is available on one of the inputs of the MultiPlus. Loads that should not discharge the battery, like a water heater for example can be connected to this output (second output available on models rated at 3 kVA and more).


Virtually unlimited power thanks to parallel operation

Up to 6 Multis can operate in parallel to achieve higher power output. Six 24/5000/120 units, for example, will provide 25 kW / 30 kVA output power with 720 Amps charging capacity.


Three phase capability

In addition to parallel connection, three units of the same model can be configured for three phase output. But that’s not all: up to 6 sets of three units can be parallel connected for a huge 75 kW / 90 kVA inverter and more than 2000 Amps charging capacity.

PowerControl - Dealing with limited generator, shore side or grid power

The MultiPlus is a very powerful battery charger. It will therefore draw a lot of current from the generator or shore side supply (nearly 10 A per 5 kVA Multi at 230 VAC). With the Multi Control Panel a maximum generator or shore current can be set. The MultiPlus will then take account of other AC loads and use whatever is extra for charging, thus preventing the generator or shore supply from being overloaded.

PowerAssist - Boosting the capacity of shore or generator power

This feature takes the principle of PowerControl to a further dimension. It allows the MultiPlus to supplement the capacity of the alternative source. Where peak power is so often required only for a limited period, the MultiPlus will make sure that insufficient shore or generator power is immediately compensated for by power from the battery. When the load reduces, the spare power is used to recharge the battery.

Solar energy: AC power available even during a grid failure

The Quattro can be used in off grid as well as grid connected PV and other alternative energy systems.

Loss of mains detection software is available.

System configuring

- In case of a stand-alone application, if settings have to be changed, this can be done in a matter of minutes with a DIP switch setting procedure.

- Parallel and three phase applications can be configured with VE.Bus Quick Configure and VE.Bus System

Configurator software.

- Off grid, grid interactive and self-consumption applications, involving grid-tie inverters and/or MPPT Solar
Chargers can be configured with Assistants (dedicated software for specific applications).

On-site Monitoring and control

Several options are available: Battery Monitor, Multi Control Panel, Ve.Net Blue Power Panel, Color Control Panel, smartphone or tablet (Bluetooth Smart), laptop or computer (USB or RS232).


Remote Monitoring and control
Victron Ethernet Remote, Victron Global Remote and the Color Control Panel.

Data can be stored and displayed on our VRM (Victron Remote Management) website, free of charge.


Remote configuring
When connected to the Ethernet, systems with a Color Control panel can be accessed and settings can be changed.

Inverter Output Watts1300W
Battery Charger Amps70A
IP RatingIP20
ColourBlue
Dimensions (HxWxD)375 x 215 x 110
Display Read OutYes
Feature3 Step Charging
Feature16A Transfer switch
Watts Output3000W Peak Output
Warranty2 Yrs
Weight10Kg

Accessories

7 other products in the same category:

Faqs